IPHONE 5S BATTERY REPLACEMENT TUTORIAL
***
Description: The tutorial you about to read is “How to replace the battery of iPhone 5S battery using DIY method” This module is provided with step by step instruction with photo.
Tools you need:
- Pentalobe Screwdriver
- Plastic / Metal Pry tool
- Suction Cup
- IPhone 5s Battery Replacement
Steps:
1.) Ready the pentalobe screwdriver and take out the 2 Screws near the base.
2.) Take the suction cup and stick it to the nearest home button and take a metal pry tool like a razor blade that fit between the screen. the suction cup acts as a holder to the upper side of the phone while the metal pry or razor blade acts as the lifting job. Note: careful with the metal pry it might damage the screen. Remember to use a plastic pry when the upper part of the screen is easy to pull over. Use a plastic pry tool to carefully Separate the screen and the iPhone module.
3.) Pull the screen carefully there is a ribbon that connects your screen to your iPhone 5s base module. (5) to dismantle it, there is little latch use a plastic pry tool and clip the module that holds the ribbon, clip it up. bend it back like a little door it will detach itself until it unsnaps. (6), clip it up. bend it back like a little door it will detach itself until it unsnap. (6)
4.) Lift off the screen. take out the 4 screws the side with the metal bracket. Note: don’t bend the screen past 90 degrees or it will damage the cables.
5.) Take out the 3 ribbon connectors.
a.) Speaking on Screen
b.) LCD on the Screen
c.) Digitilizer
You’ll have to take out your screen completely. now take out the BATTERY there are 2 screws the holds the battery connector then remove the bracket take out the little latch that connects the battery to the module use a plastic pry tool start prying from the top of the battery slide the tool underneath
6.) unstick the two stands of the sticky tape . The battery now should be free from the iphone 5s.
7.) put the battery replacement down to the iphone 5s module make sure it’s completely flat. And put the 3 pin.
0 Comment